Dovo Straight Razor Replacement Scales Ivory Micarta 623 Made in Germany


Dovo 623 Straight Razor Replacement Scales | Ivory Micarta | Made in Germany

In stock

SKU: dovoreplacementscalesivorymicarta Category:


The Dovo straight razor scales are appropriate for most 11/16″ and smaller straight razors. These scales are made of micarta that comes from within the European Union.   This is also produced in ‘anthracite‘ micarta.

Dovo shapes the blanks, polishes, and assembles the scales by hand in their factory in Solingen, Germany.

Made to Fit the 5/8 Modern Standard Razor Dimensions

Current production size 5/8 or 4/8 German razor will fit. To be sure of your particular razor as there are so many thousands of brands, measure the distance from your razor’s pivot pin hole to the furthest point away on the cutting edge. Your razor should have a measurement <113mm at this spot.

Wedge Pre-Installed & Built for Modern 5/8 Thickness

Furthermore, these Dovo replacement scales for straight razors are built with a wedge at the non-pivot pin already installed. The wedge angle is based on the presumption of the pivot pin zone of the razor needing the space of a current German 5/8, which is ~3.5mm. A range of razors can fit depending upon their tangs and your skills. If your tang is >3.5mm at metal adjacent to the pivot pin hole it may be a tight fit or a creaky install. Conversely, if the tang’s <3.4mm you may have a challenge getting the scales extra tight or need thicker washers.

Breadth of Scale Built for 5/8, Not 6/8

The maximum width across these scales near the non-pivot pin area is 18.6mm. A 6/8 razor will NOT work because the length of the razor at the heel from edge to spine would possibly “peek out” below these scales.

These anthracite micarta scales weigh approximately 31 grams.   Note that the micarta model is “torpedo-shaped” so it doesn’t fit in a lot of conventional straight razor stands (and in fact does not fit in Dovo’s own 499906 Z-shaped stand).   

Includes All Required Hardware!

You’ll get one ‘pin and rosette’ and 2 washers with your replacement straight razor scales. The scales are already given their hand-fitted-and-sanded wedge/pinning for the non-pivot end, and also already pre-drilled at the pivot pin.


To install, first remove any incumbent scale/hardware. Line up razor and scale, and put the rosette and pin in with washers between each side of the tang and inside of scales. Nail in to some soft wood, or preferably use a jewelry anvil. Crimp off the rear excess of the pin, and begin peening the backside. Use a small ball peen hammer with the pin head flush to a firm surface such as a jewelry anvil.

It helps to open the razor to the loosest point and hold in this position while hitting the rear of the pin. Hammer from various approach angles. Be certain the head of the pin touches the backing surface, and not the wood. It is a moderate skill, much like stropping and wielding the blade for its purpose.

Additional information

Weight 2 oz
Dimensions 6 × 2 × 1 in
Select Your Specimen

#3, #7, #8